The TI E2E™ design support forums will undergo maintenance from Sept. 28 to Oct. 2. If you need design support during this time, contact your TI representative or open a new support request with our customer support center.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TMDSHVMTRINSPIN: Question about ShtDwn signal

Part Number: TMDSHVMTRINSPIN
Other Parts Discussed in Thread: MOTORWARE

Dear team:

My customer want to know what is the trigger condition of ShtDwn (The red box in the image below)?

When the customer uses the routine test, every time the high voltage is applied, the signal will become 3.3V, but he has no problem with the GUI test.

Best regards

  • It's over current input signal for the power module, the power module will shut down if the input voltage is over a threshold voltage. please ask the customer to take a look at the datasheet of the power module.

  • Hi Yanming:

    The customer uses 200V/1A DC power supply for power supply, and does not use AC power supply.

    After the customer operates according to the experimental manual under the path of MotorWare\motorware_1_01_00_18\docs\labs, the motor cannot be started when the lab1b is running, that is, the overcurrent protection will occur once the high voltage is applied.

    What could be the cause?

    Best regards

  • Please ask your customer to take a look at the hardware guide of the high voltage kit, and follow it to set the kit.

    qsg_hw_hvmtr_r1p1.pdf

    C:\ti\motorware\motorware_1_01_00_18\docs\boards\drive\hvkit_rev1p1\docs

    And don't add any load on the motor ro run the lab01b, tune the variables to set the right v/f profile according to the spec. of the motor.

    #define USER_MOTOR_FREQ_LOW                                (10.0)                        // Hz - suggested to set to 10% of rated motor frequency

    #define USER_MOTOR_FREQ_HIGH                                      (100.0)                        // Hz - suggested to set to 100% of rated motor frequency

    #define USER_MOTOR_FREQ_MAX                                (120.0)                        // Hz - suggested to set to 120% of rated motor frequency

    #define USER_MOTOR_VOLT_MIN                                (3.0)                        // Volt - suggested to set to 15% of rated motor voltage

    #define USER_MOTOR_VOLT_MAX                                (18.0)                        // Volt - suggested to set to 100% of rated motor voltage