TMS320F280039C: Monitor and tune parameters in simulink (F280039c)

SRI RAM M A

Part Number: TMS320F280039C
Other Parts Discussed in Thread: C2000WARE

Hello ,

i am trying to read a potentiometer using adc block. i m using c280039c control card connected to the docking station. i am able to build the code but when i try monitor and tune, it gives an error .

"Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command"

i have attached my model with this thread. the pic attached is my comm port numbers.

adc_ti.rar

over 1 year ago

0 Santosh Jha over 1 year ago

TI__Guru 50430 points

Hi SriRam,

I will recommend you to try C2000Ware ADC example and check if your hardware setup is working. You can try even basic example from C2000Ware SDK.

C:/ti/c2000/C2000Ware_4_01_00_00/driverlib/f28003x/examples/adc

Can you check if you can run the ADC or other example?

Thanks & Regards,

Santosh

0 Santosh Jha over 1 year ago in reply to Santosh Jha

TI__Guru 50430 points

Sriram,

We did not hear from you, so I am assuming the issue has been resolved. I am closing the thread.

Thanks & Regards,

Santosh

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F280039C: Monitor and tune parameters in simulink (F280039c)