• State Resolved
  • Locked Locked
  • Replies 4 replies
  • Subscribers 81 subscribers
  • Views 157 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TMS320F28386S: GEL Expression: GEL_Go

John Hite
Expert 1355 points
Part Number: TMS320F28386S

I was walking through some code using Run to Line and this popup, GEL Expression: GEL_Go, appears. It never stops.

Could you tell me what and why?

Thanks,

JH

  • 0
    TI__Guru 50430 points

    John,

    Is this same issue you created another post? You mentioned that it is using CCS3 or it is newer CCS?

    If it is on same topic, then I will close duplicate thread.

    Regards, Santosh

  • 0 in reply to Santosh Jha
    Expert 1355 points

    In another thread the device was CCS3 but I just chose from the dropdown assuming it was CCS3. That thread was about the cursor moving not GEL so it is not a duplicate.

  • 0 in reply to John Hite
    TI__Guru 50430 points

    In both threads you mentioned 'Run to Line'. I am not sure if I understand your setup.

    So you have two projects, and in both projects you are facing issue in 'Run to Line' feature?

  • 0 in reply to Santosh Jha
    Expert 1355 points

    Thanks for your diligence. One thread was about the Gel expression, run to line was just a means to get to the problem. I do not think I had a run to line problem.

    The other thread where I mentioned run to line was Cursor moves...

    Again, run to line was not suspect it was just that I had set a run to line position while the project was building. That point was in a different file from main. The debugger always sets the cursor to the opening bracket of main(), jumping away from where I was working.