TMS320F280049: fully digital controlled peak current mode reference design

user4811888

Part Number: TMS320F280049
Other Parts Discussed in Thread: PMP23126, TIDM-02000

Hi expert,

I have seen some peak current control reference design using C2000 by internal DAC and comparator, that's good actually however could I learn that if any fully digital scheme for peak current control with C2000?

Implementing peak current mode control of a switch-mode power supply

Digital Peak Current Mode Control With Slope Compensation Using the TMS320F2803x (Rev. A)

Peak Current Mode Controlled PSFB Converter Reference Design Using C2000 Real-t (Rev. B) (ti.com)

Fully digital means using ADC to sample inductor current continuously and the inner current loop are processed fully inside MCU in digital format, including slope compensation.

If there's no such design presently, is C2000 able to realize this kind of digital control, if not, what is the limitation here?

Many thanks.

over 1 year ago

0 Qing Ye over 1 year ago

TI__Intellectual 1200 points

Hi,

Please check TIDM-02000 or PMP23126 in DPSDK. Both are PCMC control and fully enabled by C2000.

Thanks,

Qing

0 user4811888 over 1 year ago in reply to Qing Ye

Intellectual 530 points

Hi,

I have checked above, it is still mixed-signal peak current control, the inductor current is sent to internal comparator instead of ADC.

What I would like to find is a scheme in which the inductor current is sent to ADC directly.

0 Qing Ye over 1 year ago in reply to user4811888

TI__Intellectual 1200 points

Hi,

The HV current is sent to one of CMPSS port, which is also an analog port, for PCMC control. That is how PCMC is implemented for TIDM-2000 and PMP23126. I was not able to help you find one example of PCMC implemented without CMPSS.

0 Richard Scott over 1 year ago in reply to user4811888

Prodigy 30 points

Hi,

ADC conversion rates are not high enough on a C2000 for PCMC (this is generally true for microcontrollers). The control loop needs to detect and react to the inductor current reaching the threshold in a tiny fraction of the PWM period for precise control. This is why the analogue comparator is used to provide a trip signal rather than an ADC and digital comparator.

0 user4811888 over 1 year ago in reply to Qing Ye

Intellectual 530 points

got it, thanks!

0 user4811888 over 1 year ago in reply to Richard Scott

Intellectual 530 points

Understood, thanks for comments.

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F280049: fully digital controlled peak current mode reference design