Other Parts Discussed in Thread: UNIFLASH
There is a selection for On-Chip Flash under tools and I have used it to control flash erase during builds. Is there any other way to control which areas of flash are erased during a build?
Thanks,
John
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
There is a selection for On-Chip Flash under tools and I have used it to control flash erase during builds. Is there any other way to control which areas of flash are erased during a build?
Thanks,
John
John,
You can also use uniflash tool.
https://www.ti.com/tool/UNIFLASH
It is mentioned in f2838x product page.
https://www.ti.com/product/TMS320F28388D#software-development
Regards, Santosh
Thanks Santosh.
As is often the case I did not do a good job of presenting my question. What I meant to ask is whether there was a way to control it as part of the build process. But actually I see no reason to erase all blocks as a default. So I will just leave it set to erase as needed unless there is a problem.