Hi,
I am working on DRV8353RS-EVM (F28027) development kit. I am unable to program this kit by motor wave software. Kindly connect your engineer with us.
Thanks & Regards
Shadab saifi
Contact no:- 8700440769
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi,
I am working on DRV8353RS-EVM (F28027) development kit. I am unable to program this kit by motor wave software. Kindly connect your engineer with us.
Thanks & Regards
Shadab saifi
Contact no:- 8700440769
Hi Shadab,
1. What error appears when you try to program the EVM?
2. Does the EVM work if you use the DRV8353Rx software available on at dev.ti.com?
Best regards,
Joshua
Hi Joshua,
1. Please check this error comes after software installation. Please confirm whether we have done right installation as per the demo board.
2.If not, then share the link of the required software which will work with the mentioned EVM board earlier.
Please support on priority basis as we need to run our motor with your demo board for validation.
Thank you
Do we need to install this software mentioned in the below attached image:-
Thank You
Hi Shadab,
If you're trying to use the DRV8353RS-EVM with the F28027F board it comes with, have you tried following the instructions in the guides below?
Alternatively, this EVM is supported by newer C2000 devices and EVMs in the Universal Motor Lab (found in the MCSDK). Linking to the User's Guide below:
https://www.ti.com/lit/spruj26
Best,
Kevin
Hi Kevin,
I am using DRV8353RS-EVM with the F28027F board i am unable to program the board. Please Check the below software list: -
1- Motor ware
2- Code Composer Studio
3- DRV8353Rx-1.0.0
4- GUI Installer V2.0
Please let us know the sequence of the software how they can be integrated with the EVM board as We can see there is some interdependency of all.
Regards
Shadab saifi
Hi Shadab,
Could you try running the below GUI for motor control?
https://dev.ti.com/gallery/view/5063756/DRV8353Rx/ver/1.0.1/
This GUI is available online and should only require a connection from the EVM to your laptop via USB.
Regards,
Anthony Lodi