TIDM-02010: TMS320F2800137_temprature_sensor

Babaji,

TEMP_ENVI can be sensed using Pin 28 ( A18/C18,GPIO21) of F280013x. Please populate R108 and DNP R106 to connect this sensor to ADC.

This arrangement is to ensure boards compatibilty with F28002x where pin 28 is reserved for VDDIO where you have to populate R106 and DNP R108. Please refer the notes in this schematic (MCU page) for the same. 

Regards,

Sumit

Thank you !

I was changed as per above...now we have to implement code for ADC please guide how to initialize & so on.

now please guide for code (software) related .

Dear sumit, 

How to merge ADC code into existing code?? 

Hi Babaji,

If you are using published example on TIDM02010 located at following location then there is no need to merge anything - C:\ti\c2000\C2000Ware_MotorControl_SDK_5_00_00_00\solutions\tidm_02010_dmpfc\f280013x

If you are using your custom code then you can refer to C2000 academy at following location to learn more about how to implement ADC and how to merge code. Please refer the follwing link - https://dev.ti.com/tirex/explore/node?node=A__AfMa1bhaXie8CQhJptfHnQ__C2000-ACADEMY__3H1LnqB__LATEST

Dear Sumit,

as per above we follow step but there is not ADC code example here.

so please guide how to implement ADC in our project because project is delay due to ADC Part is pending.

Sumit Patil1 said:

C:\ti\c2000\C2000Ware_MotorControl_SDK_5_00_00_00\solutions\tidm_02010_dmpfc\f280013x

download these.

Sumit Patil1 said:

If you are using your custom code then you can refer to C2000 academy at following location to learn more about how to implement ADC and how to merge code. Please refer the follwing link - https://dev.ti.com/tirex/explore/node?node=A__AfMa1bhaXie8CQhJptfHnQ__C2000-ACADEMY__3H1LnqB__LATEST

we follow these steps but here not ADC example.

Please guide.

Any update !!!!!!

Please take Remote if you possible,tell time & integrate temperature sensor its urgent.

Dear sumit,

Now we have to implement T_EVAP & T_PIPE (J18)  .

Also Please send details of J6 EVV

in hardware what is change in TIDM-02010E32 board?

Hi Babaji,

There are no hardware changes required for EVV. As you can see in the schematic of the TIDM02010E32, assigend pins are just GPIO which are level shifted to 12V using darlington pair with current driving capabilities.It can drive two phase bipolar stepper motor. Unfortunately, there is no software example published for EVV in TIDM02010 since requierment varies system to system.

Regards,

Sumit

This point is Debbuger issue