• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 82 subscribers
  • Views 103 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

TIDM-1000: TIDM-1000: Openloop set-up

TIDM-1000: TIDM-1000

Vedat Sancak
Prodigy 30 points
Other Parts Discussed in Thread: TMDSCNCD28379D, TIDM-1000, SYSCONFIG

Hi,

I want to use TIDM-1000 "pfc3phvienna_F2837x" code on  "TMDSCNCD28379D", I launch main.syscfg, all rectifier parameters such as inductance values, RC sense filter values, voltages etc. are defined, I can change them.

When I click "Device Vİew" I get "F28004x (Device) F28004x_100PZ (Part)" and I think that I should change it  to "F28379D". 

How can I change it and should I define PWM, ADC, GPIO pins according to "Table 2. Key Controller Peripherals Used for Control of Power Stage on Board" in "Design Guide: TIDM-1000 TIDUCJ0G–November 2016–Revised April 2020" ?

Regards,

Vedat