RESET Controller

Dharmendra Savaliya

Intellectual 700 points

Hello,

How we can reset Our C2000 F28027 launchpad Manually By Using Software .....???

Thank You.

over 10 years ago

0 Gautam Iyer over 10 years ago

Guru 192875 points

Hi Dharam,

You can use Watchdog timer. Also, check this thread: e2e.ti.com/.../21505

Regards,
Gautam

0 Dharmendra Savaliya over 10 years ago in reply to Gautam Iyer

Intellectual 700 points

Yes sir,

we have ask que on that post (https://e2e.ti.com/support/microcontrollers/c2000/f/171/p/21505/1688989#1688989)...
WD reset is full reset(HARD) OR Custom reset ?
May WD reset only Start from main()
But we want to reset and start from codestart ...
How can we Use watchdog interrupt to JUMP to codestart ?

Thank you.

0 Dharmendra Savaliya over 10 years ago in reply to Gautam Iyer

Intellectual 700 points

Yes Sir,

we can do WD reset,
but after we have to again configure WDKEY to 101
& WD reset is full reset OR custom RESET(Hard reset)?

Thank You

0 Gautam Iyer over 10 years ago in reply to Dharmendra Savaliya

Guru 192875 points

Refer to Lori's post here: e2e.ti.com/.../920394

0 Dharmendra Savaliya over 10 years ago in reply to Gautam Iyer

Intellectual 700 points

Thank You Sir,
Got Answered.

0 Gautam Iyer over 10 years ago in reply to Dharmendra Savaliya

Guru 192875 points

You're Welcome!

Goodluck & Regards,
Gautam

C2000™︎ microcontrollers

C2000 microcontrollers forum

RESET Controller