Other Parts Discussed in Thread: C2000WARE, TMDSCNCDH52C1
Hi,
I am working on TMDSDOCKH52C1 and using F28M35xx control card. I am facing an issue regarding UART RX interrupt handler.
I am using GPIO28 & 29 UART0. When I send some data through UART and short these two GPIOs, I get UART handler and data is received back.
But when I use and connect FTDI FT2232 USB for serial communication with my PC, my data gets transmitted but in reply sending from PC serial Interface my UART handler does not come.
For your reference:
1. I have made position 2 of SW3 on control card as OFF
2. Using Putty on Windows10 as serial Interface
Kindly help in sorting this.
Thanks
Ravin