Tool/software: Code Composer Studio
C2000 support,
In CLA Handson Workshop demo the external connection is
In Launchpad F28379D Overview
According to the PCB they should be J30 and j80. Please confirm.
Best regards,
Jingtai
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Tool/software: Code Composer Studio
C2000 support,
In CLA Handson Workshop demo the external connection is
In Launchpad F28379D Overview
According to the PCB they should be J30 and j80. Please confirm.
Best regards,
Jingtai
Jingtai,
We are checking on this issue, will be getting back to you soon
Regards,
Peter
Jingtai,
I am having difficulty understanding your question - could you please provide more detail
You stated that "according to the PCB they should be J30 and J80". What is "they"?
Thanks,
PEter
Peter,
I'm sorry for my mistake. It should be J3-30 (ADCINA0) in table 5 and J8-80 (EPWM4A) in tabe 8.
Regards,
Jingtai
Jingtai,
Yes, from the information that you sent it appears that there is indeed a mismatch between the drawing the the tables regarding the endpoints of the jumper cable. I have contacted the course designer to provide explanation. In the mean time, have you been at all successful in establishing this connection by following the tables?
Regards,
Peter
Jingtai,
ADCINA0 is header J3, pin #30 (and not pin #9 as shown on the slide)
EPWM4-A is header J8, pin #80 (and not pin #54 as shown on the slide)
EPWM1-A is header J4, pin #40 (just in case you need it)
You are correct, however you should refer to them as pin numbers rather than ‘J’ which we use for header numbers.
Regards,
Peter
Peter,
Thank you.
I will repeat the CLA Handson Workshop program.
Regards,
Jingtai