This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LAUNCHXL-F28027: JTAG probe programing

Part Number: LAUNCHXL-F28027
Other Parts Discussed in Thread: TMS320F28026

Hi

I am using LAUNCHXL F28027 to program my TMS320F28026. My JTAG interface as below

And I found same pin define on LAUNCHXL F28027, so I solder a wire on those PADs and connect to my JTAG connector.

But I will see a warning message as below. Is there any wrong setting? or the LAUNCHXL F28027 is not contemptible with my IC?

  • Hi,

    You're target device is a F28026 then?Looks like you can connect to your device and attempt programming OK, correct? Just having a warning about the memory mapping.

    Can you check that your target config file and linker command file match up for this specific device and its memory map (see datasheet for memory map).

    The following App Report goes into details on debugging JTAG issues: http://www.ti.com/lit/spracf0 

    Best,

    Kevin