CCS/TMS320F28377S: Setup Dual CAN modules (CANA and CANB)

Nisal Bulathsinghala

Part Number: TMS320F28377S
Other Parts Discussed in Thread: CONTROLSUITE, C2000WARE

Tool/software: Code Composer Studio

Hi,

I am trying to setup the CAN buses in the LAUNCHXL-F28377S. However non of the examples seem to work for this board.

I tried the examples given in the controlSuite as well in C2000Ware. If someone has managed to setup both the CAN buses to

run simultaneously please give me advice to get it up an running.

Thank you

Nisal

over 6 years ago

0 Joseph Casuga over 6 years ago

TI__Mastermind 41340 points

Hi Nisal,

Apologies for missing a response on your question. Would you please let me know which of the examples you tried running with the launchpad? Also note that the CAN transceiver on the launchpad is configured to connect to GPIO70 and 71 for CANRXA and CANTXA respectively. Hope you had these CAN pins configured accordingly in the CAN examples that you have tried out.

Regards,

Joseph

0 Nisal Bulathsinghala over 6 years ago in reply to Joseph Casuga

Prodigy 250 points

Hi Joseph,

Thank you for the reply. I managed to get both the CAN buses up and running using the driverlib examples. Thank you very much for taking the time to help me out.

Regards Nisal

C2000™︎ microcontrollers

C2000 microcontrollers forum

CCS/TMS320F28377S: Setup Dual CAN modules (CANA and CANB)