Other Parts Discussed in Thread: MOTORWARE
Tool/software: Code Composer Studio
Derived from motorware proj_lab10d 。20hz hall to fast fast angle is not allowed。
Derived from motorware proj_lab11d 。20hz hall to fast fast angle is very good. (Already mass produced) The same pcb!
now
Derived from motorware proj_lab10d : progrma1, Derived from motorware proj_lab11d : progrma2 , there pcb1 ,pcb2 Same batch production。
progrma1 into pcb1 fast angle is not allowed。
progrma1 into pcb2 ok
progrma2 into pcb1 ok
progrma2 into pcb2 ok
What causes fast not allowed?