Other Parts Discussed in Thread: LVSERVOMTR,
Hello, I'm trying to set up a test with the KIT LVSERVOMTR,
the LAUNCHXL-F28069M launchpad and the BOOSTXL DRV8305EVM driver.
I haven't found the documentation to connect in the right place
the J10 and J4 connectors of the motor kit to the QEP_B and QEP_A sockets
on the F28069M Launchpad.
REMARK:
The marker for pin 1 on each connector does not seem correct to me. For J4 it is on GND (pin1), for J10 it is opposite (Pin5)
Do you have any documentation or answer..
Thanks in advance
