TMDSSOLARUINVKIT: TMDSSOLARUINVKIT: How to make it work.

Thank you for the response. I was working with the ControlSuite software as you had suggested. Page 6 of the quick start guide for this part has the following instructions. Step 2 requires having GUI composer and I do not know where to find this program.

Hi Manish,

Thank you for the response. I am following your suggestion and am able to communicate with the equipment. I had a question about hooking up the equipment to the grid. Does connecting to the grid simply mean connecting the output of the inverter (TP15 and TP16) to a wall plug, or should it go to the main panel of the house?

I am referring to the figure below when asking this question.

Anurag, 

This design is meant to help you understand the system and is not a complete end equipment design, and only to be tested under lab environment.

I will recommend testing it with AC source and emulated connection as described in the UG. 

-Manish 

Thank you. I have a follow up question as I am still having an issue with the board to work. I am following instructions on page 32 of the User guide. I have set the Build = 1, MPPT = 0, Grid_Connect = 0.

I have an 800 ohm resistor connected between TP8/9 and TP10and have connected a 50V power supply between TP12 and 13. Here is what I am seeing:

1. The system is not drawing any current from the power supply.

2. I follow instructions on page 34 of the UG and set the value of ClearFlyBacktrip = 1. However, when I do this the EPwm3Regs.TZFLG.all variable does not go to 0. Its value remains at 8

3. I do not measure any significant voltage between TP8/9 and TP10. 

I would appreciate any help in figuring this issue out.

Thanks