power supply problem in concerto control card

Iragouda Patil1

Other Parts Discussed in Thread: TPS62291

i am using F28M35x concreto controller here unable to generate the 3.3 volt power in concerto controller .input side getting 5 volt but output side is getting 0.5 volt in TPS62291 ic , i am monitor on TP8 pth

so can any one give solution for this problem .

Regards

patil

over 10 years ago

0 Joe Prushing over 10 years ago

TI__Genius 11981 points

Patil- it sounds like a defective control card to me. Did it work at one time or have you had this problem since you received it? If you purchased the control card through the eSTORE, you can contact customer support to see if you qualify for a replacement (https://estore.ti.com/faq.aspx#q5.1). If you received it from a sales rep, FAE, or university program, you'll need to contact them.

Good luck, Joe

C2000™︎ microcontrollers

C2000 microcontrollers forum

power supply problem in concerto control card