Sample code for Clark Transformation

Naveen Vureli

Other Parts Discussed in Thread: CONTROLSUITE

Hello,

I am using F2808 Micro controller to control an induction motor. I am using simulink to program my micro controller. I have been using the predefined block from embedded coder like clark and park transformation. I am confused about the code generated by simulink. Is it possible to provide the code any one how is using simulink to program texas micro controllers. So tht i would like to compare it with my program.

Please help me

thanking you

Vureli Naveen.

over 11 years ago

0 Gautam Iyer over 11 years ago

Guru 192875 points

Hi,

Go through this doc for more info:

http://www.ti.com/lit/an/spra588/spra588.pdf

Regards,

Gautam

0 Igor Gorbachev over 11 years ago

Guru 20525 points

Hello!

I would recommend this path in controlSUITE ti\controlSUITE\libs\app_libs\motor_control\math_blocks\v4.2\

Regards,

Igor

0 Naveen Vureli over 11 years ago in reply to Igor Gorbachev

Prodigy 125 points

Hello,

thank you for the reply, I installed DMC(Digital motor control) library in my PC. their texas as given the code for clark and park transformation ... but i could not see similar code generated by simulink .. thi sis the reason I requested for sample code generated from simulink for clark and park transformation.

thanking you

Vureli Naveen

0 yogesh tatte over 9 years ago in reply to Igor Gorbachev

Prodigy 20 points

Sir, i am using maths block of calculating three ac phase voltages from dc bus and switching instances from the same motor_control /math_ blocks but unable to get the alpha and beta values.
please help

Because of the holidays, TI E2E™ design support forum responses will be delayed from Dec. 25 through Jan. 2. Thank you for your patience.

C2000™︎ microcontrollers

C2000 microcontrollers forum

Sample code for Clark Transformation