Hi!
I am developing on a F28335 right know using the Experimenters Kit. However I am quite close to the controller limitations and consider switching to an F28377D. Because I have a lot of designs around the 100pin experimenter board, I would like to keep it (the limited number of GPIO pins or peripherals are not a major concern). Now there is this TMDSADAP180TO100 board that would connect the F28377 controlCARD to the old 100pin board.
I could not find a pinout table/schematic of this adapter anywhere. It would be very good, just to verify that everything (!) is exactly the same as before, so that pre-designed pcbs for the old dock will still work.
Thanks a lot