F28335 ControlCARD Release 2.2 pin-out/compatibility

JAMGRESS

Other Parts Discussed in Thread: CONTROLSUITE

I've been using the F2833X series card shown on top in the images below. I've replaced all instances of this board with the F28335 controlCARD release 2.2 card shown below the previous card. The layouts of the boards are obviously very different. Should I expect and compatibility issues with my system? Are the pin-outs identical? Thank you.

over 8 years ago

0 Billy Stevers over 8 years ago

TI__Prodigy 350 points

Hello,

Both boards should have the same pinout. Which revision is the "previous board" you describe?

If you take a look at the infosheet for the device in:
controlSUITE\development_kits\~controlCARDs\CC2833xHWdevPkg

you will find the main difference between revisions is that the older controlCARDs do not include SW1 or SW2. These control the RS-232 connection and device boot options, respectively.

Kind regards,

Billy Stevers

0 JAMGRESS over 8 years ago in reply to Billy Stevers

Prodigy 20 points

Sorry for any confusion. The previous board would be the rev. 1.2 (pictured above in the image.)

Thank you,

-James

0 Billy Stevers over 8 years ago in reply to JAMGRESS

TI__Prodigy 350 points

James,

Looking at the R1.2 and R2.0 schematics in controlSUITE confirms what the infosheet says. The pinouts are the same and R2.0 includes SW1 and SW2. Of course there are minor component changes in various areas of the board, but these changes do not effect the pinout.

I hope this answers your question!

Kind regards,

Billy Stevers

0 Billy Stevers over 8 years ago in reply to JAMGRESS

TI__Prodigy 350 points

James,

Was your question answered? If so please verify an answer.

Kind regards,

Billy Stevers

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

C2000™︎ microcontrollers

C2000 microcontrollers forum

F28335 ControlCARD Release 2.2 pin-out/compatibility