Other Parts Discussed in Thread: TMDSCNCD28379D, , HVPMSMMTR, CONTROLSUITE
I have a TMDXIDDK379D board, HVPMSMMTR (PMSM motor) with TMDSCNCD28379D controlCARD (with Delfino F28379D MCU). I was wondering how to run the motor through this board or what and how to give commands to the control card to operate the motor. I saw an example CCS project on Design Drive and following IDDK user's guide's (Level 1) example CCS project steps to connect to the board. Level 1 didn't need the motor. I didn't find instruction for level 2 - 5. I was wondering if I can use this CCS project with different levels to run the motor or is there any other GUI or other program to give the board commands?
I am attaching the user guide found on the product page.sprui44.pdf
