This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

  • TI Thinks Resolved

TMDXIDDK379D: How to run a motor using TMDXIDDK379D.

Prodigy 160 points

Replies: 1

Views: 46

Part Number: TMDXIDDK379D

I have a TMDXIDDK379D board, HVPMSMMTR (PMSM motor) with TMDSCNCD28379D controlCARD (with Delfino F28379D MCU). I was wondering how to run the motor through this board or what and how to give commands to the control card to operate the motor. I saw an example CCS project on Design Drive and following IDDK user's guide's (Level 1) example CCS project steps to connect to the board. Level 1 didn't need the motor. I didn't find instruction for level 2 - 5. I was wondering if I can use this CCS project with different levels to run the motor or is there any other GUI or other program to give the board commands?

I am attaching the user guide found on the product page.sprui44.pdf

  • Look at the folder

    C:\ti\controlSUITE\development_kits\TMDSIDDK_v2.0\IDDK_PM_Servo_F2837x_v2_00_00_00\~Docs

    for user guide.

    Few levels up, you will find all related information for the kit and the evaluation software.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.