LAUNCHXL-F28027F: failed to upload the code to the board using Simulink

zhongying wang

Part Number: LAUNCHXL-F28027F
Other Parts Discussed in Thread: C2000WARE

Hi, I am a new user of C2000 Launchpad. Today I tried to upload the code to my board F28027F. But it failed. I guess there is something wrong with my setting for connection port in my laptop. Pls help me how to identify and correct it?

Many thanks!

Joey

over 3 years ago

0 Santosh Jha over 3 years ago

TI__Guru 50430 points

Hi Zhongying,

Can you try to connect the target through CCS first and check if you are able to connect to the target and run some C2000ware example?

0 zhongying wang over 3 years ago in reply to Santosh Jha

Prodigy 150 points

Hi, I tried to open a new projet through CCS when I was verying the connection by selecting XDS100v2 or v1 but failed as shown below

0 zhongying wang over 3 years ago in reply to Santosh Jha

Prodigy 150 points

Hi, Santosh

I tried to use CCS and is not working as it failed when I 'verify' the connection by selecting XDS100v1 or v2 port.

Thanks!

0 Santosh Jha over 3 years ago in reply to zhongying wang

TI__Guru 50430 points

Hi,

The picture didn't came through. Can you resend the picture?

Also, you need to use XDS100v2. Please refer to the User's guide for the instruction to get started.

LAUNCHXL-F28027 C2000 Piccolo LaunchPad experimenter kit (Rev. C)

0 zhongying wang over 3 years ago in reply to Santosh Jha

Prodigy 150 points

I wrongly put the switch 3 on the 'off' state. Now back normal.

Thanks!

C2000™︎ microcontrollers

C2000 microcontrollers forum

LAUNCHXL-F28027F: failed to upload the code to the board using Simulink