CCS/TMDSPREX28335: LOAD PROGRAM ERROR

Sajad Rather4

Part Number: TMDSPREX28335

Tool/software: Code Composer Studio

Hello All,

I am having a Kit TMDSPREX28335, I have imported a Program from Control Suite EPWM one,and tried to load it on board,but the board gives error given below

anyone please a little help will be appreciated.

over 5 years ago

0 Gautam Iyer over 5 years ago

Guru 192875 points

Hi Sajed,

Did you go through the Quick start guide for the kit? Its available here: www.ti.com/.../TMDSPREX28335
Just check the SW positions and other configurations recommended.

Regards,
Gautam

0 Sajad Rather4 over 5 years ago in reply to Gautam Iyer

Expert 1655 points

Hello Gautam,

Yes i have gone through the quick start guide,

As far i know,i think the problem is due to control card.
As i have other kit of same Part number ,which shows no error as of such, Also i tried to replace the control card then it works fine.

0 Ozino Odharo over 5 years ago in reply to Sajad Rather4

TI__Genius 14261 points

Sajad,

What device is shown in your target configuration file (.ccxml)? Does it match the device in use? If not, update the settings to match and try and see if that resolves the target configuration error.

Regards,
Ozino

C2000™︎ microcontrollers

C2000 microcontrollers forum

CCS/TMDSPREX28335: LOAD PROGRAM ERROR