UNIFLASH: Version: 6.1.0.2829

Rich Bontrager

Part Number: UNIFLASH

After starting the uniflash tool on a WIndows 10 computer, the "New Configuration Choose Your Device" tab opens a window that reports "LOADING DEVICE LIST". This window never clears.

The tool does allow one to select a configuration file on "Create Session From Existing Target Configuration File" tab but the Start Button will not start the session.

over 3 years ago

0 Bin Liu over 3 years ago

TI__Guru*** 125266 points

Hi Rich,

The "LOAD DEVICE LIST" is a pulldown list, it should go away once you selected a device from its list. Then the "Start" button becomes accessible.

0 Rich Bontrager over 3 years ago in reply to Bin Liu

Prodigy 50 points

Thanks for the response.

After 15 minutes, the pull down list never disappears. Are there some underlying ports being used by the tool, my corporate virus protection software blocks?

0 Bin Liu over 3 years ago in reply to Rich Bontrager

TI__Guru*** 125266 points

What is the device you are trying to access using Uniflash?

0 Rich Bontrager over 3 years ago in reply to Bin Liu

Prodigy 50 points

tms570lc43xx

0 QJ Wang over 3 years ago in reply to Rich Bontrager

TI__Guru**** 186196 points

There is not any problem on my test. I tried Uniflash 6.1.02829. When clicking the device "TMS570LC43x", device list goes away, and emulator list comes up.

There is also no problem to select the existing configuration file.

Arm-based microcontrollers

Arm-based microcontrollers forum

UNIFLASH: Version: 6.1.0.2829