I have some issues while debugging with that launchpad or rather it's related to CCS I think. Sometimes I cannot debug or run firmware on launchpad until I restart CCS. In debug window there is no any active debug sessions. I can run debug again, CCS asks if I want to terminate the previous sessions, new program is compiled and loaded to the board and it stays with red LED lit, that one of EZ-FET part. No any error. Nothing happens. Disconnecting board doesn't help, switching projects, disconnecting USB, changing ports, just nothing. Also for some unknown reason I often don't have load button active, then after some debugging it shows up finally. I use CCS 10. Is there any way to improve this situation?