Other Parts Discussed in Thread: MSP-FET
Hi,
My customer is thinking to use BSL UART to write their firmware on MSP430FR2676.
I checked a few documents (slau319ab.pdf, slau550aa.pdf) and found MSP-FET or MSP-BSL"Rocket" is needed as communication bridge.
I understood UART TX, UART RX, nDTR, nRTS are needed other than power and GND.
The customer wonders if generic USB-to-UART cables (FTDI 3.3V cable) can be used instead of above TI specific products.
Is this possible?
If not, is there other method to write a firmware using USB-to-UART cable?
Thanks and regards,
Koichiro Tashiro