Other Parts Discussed in Thread: MSP-EXP430FR5739, MSP-FET, UNIFLASH
Number: CS0972047
Contact: Thorne Kontos
First name: Thorne
Last name: Kontos
Short description: Pulling test program image off a programmed part
Email: thorne.kontos@integra-tech.com
Company: Integra Technologies LLC
Company phone:
Language: English
State: Open
Provide case details or comments:
Here is my problem:
I have some programmed parts, but the engineer did not save the programming executable to a file so we could program additional parts. Is it possible to pull the test program image/executable off one of these already programmed parts?
We used the FRAM MSP-EXP430FR5739 Experimenter's Board to act as the interface between the programming software and the DUT card that we use on a Teradyne J750 tester. Development was done using Code Composer Studio 11.1.0
Thank you for any help you could offer in resolving this dilemma.
THank you,
Thorne Kontos
Integra Technologies LLC