MSP430FR6043: some issues of anemometer application

Yale Li 李耀先

Part Number: MSP430FR6043

Hi Team,

Based on slaa969_High-Resolution Anemometers provided configurations, the USS_SEQUENCE_SELECTION in header file generated by USS is CH0_CH1.

And based on the hardware, is the maximum quantity of transducer which connected directly(without mux) with the evm board two?

How to determine TOF_UPS, TOF_DNS and deltaTOF belonging which Channel? Does this matter?

Thanks & Regards

Yale Li

0 Yuhao Zhao over 1 year ago

Hi Yale,

Sorry I don't know much about this, but I'll get back to you after asking the relevant experts.

Thanks and Best Regards

Yuhao Zhao

0 Yale Li 李耀先 over 1 year ago in reply to Yuhao Zhao

Hi Yuhao,

May I know the status of this thread?

Thanks & Regards

Yale Li

0 Yuhao Zhao over 1 year ago in reply to Yale Li 李耀先

Hi Yale,

My colleague is on vacation. I will reply as soon as I contact him.

Thanks and regards

Yuhao

0 Yuhao Zhao over 1 year ago in reply to Yuhao Zhao

Hi Yale,

Based on the hardware, is the maximum quantity of transducer which connected directly(without mux) with the evm board two?

How to determine TOF_UPS, TOF_DNS and deltaTOF belonging which Channel? Does this matter?

Here is some content in page 2 of slaa969_High-Resolution Anemometers
- This ultrasonic subsystem (see Figure 1-1) first excites an “upstream” transducer connected to CH0_OUT while capturing the waveform from a “downstream” transducer connected to CH0_IN.
- The ultrasonic subsystem subsequently excites the “downstream” transducer connected to CH1_OUT while capturing the waveform from the “upstream” transducer connected to CH1_IN.
TOF_UPS is for “upstream” and TOF_DNS is for “downstream”.

Thanks and Best Regards

Yuhao Zhao

**Attention** This is a public forum

MSP low-power microcontroller forum