Other Parts Discussed in Thread: MSP-EM-DESIGN-CENTER
Hello there.
i'm getting a lot of help from you. Thank you
I'm developing a power metering module using msp430i2031.
and the interface has been changed from the UART to I2C.
so i have a question here.
currently, to calibrate its voltage and current,etc., i hvae to use MSP-EM-DESIGN-CENTER, but I know that it only supports UART Interface (via HID USB) method.
so i was wondering if there is any other way to calibrate it without this software(MSP-EM-DESIGN-CENTER). Or do I have to connect the I2C interface with the MSP-EM-DESIGN-CENTER?
please answer about my question.
Thank you