EVM430-FR6047: Capturing output of GPM from EVM430-FR6047 to another board Ardunio/NRF

Jaskarn Jit

Part Number: EVM430-FR6047

I am using the EVM430-FR6047 board with the clamp-on transducers. I can see the TOF, GPM on the board LCD and also on the US Design Center UI.

I would like to capture this data out to our processor. I can try out with Ardunio or preferably the NRF52 board.

Appreciate it if you can help with any related documentation procedure to do so and any sample scripts I can use.

Thanks

over 1 year ago

0 Jaskarn Jit over 1 year ago

Prodigy 40 points

I read through some documentation and tried to get the data on the console using Putty but don't have success. See attached screenshots. Any help is appreciated.

IMG_6811pdf.pdf IMG_6809pdf.pdf

0 Jaskarn Jit over 1 year ago in reply to Jaskarn Jit

Prodigy 40 points

0 Johnson He over 1 year ago in reply to Jaskarn Jit

TI__Mastermind 28426 points

Hi Jaskarn,

Firstly, I find your metering result is not good, you need to tuning some parameter to get more ADC waveform and result.

Then if you need to output some result, like flow rate, volume, you can try to check USS code and add some communication interface to put those data, like UART.

Some general example code as your reference:

https://dev.ti.com/tirex/explore/node?node=A__ALlQ8TQBkgGtFo0cTvhy2Q__msp430ware__IOGqZri__LATEST

Thanks!

Best Regards

Johnson

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

EVM430-FR6047: Capturing output of GPM from EVM430-FR6047 to another board Ardunio/NRF