Other Parts Discussed in Thread: MSP430FR6047,
Tool/software:
Hello Texas Instruments Community,
I’m encountering an issue when connecting my MSP-FET430UIF debug interface to my MSP430FR6047 microcontroller. Every time I attempt to start a debug session, I receive the following error:
"Error initializing emulator: Could not set device Vcc."
Steps I’ve Tried So Far:
- Checked Connections: I verified that all the physical connections between the MSP-FET430UIF and the MSP430FR6047 are secure and correctly aligned.
- Firmware Update: I tried updating the firmware for the MSP-FET430UIF as suggested, but the error still persists.
- Voltage Check: I measured the voltage output from the MSP-FET430UIF, but it does not seem to provide power to the target device (the MSP430FR6047).
- Restarted Setup: I disconnected and reconnected all components, as well as restarting my computer, but the issue remains.
Issue:
The MSP-FET430UIF is not supplying power to the MSP430FR6047, preventing me from debugging the device. I’ve followed common troubleshooting steps without success, and I would appreciate any suggestions on how to resolve this problem.
Has anyone else encountered a similar issue or can offer advice on further steps I can take? Your help would be greatly appreciated!
Thank you in advance for your support.
Best regards,
faizan Ashraf
