EVM430-FR6043: Reducing F1 value in FR6043

Rama Balachandran

Part Number: EVM430-FR6043

Tool/software:

Hi,

I would like to use EVM-FR6043 with 48kHz/50kHz transducer. Is it possible to reduce F1 to this value? Any help regarding this matter is appreciated.

Best wishes.

3 months ago

0 Diego Abad Sajamin 3 months ago

TI__Genius 10462 points

Hi Rama,
This value can't be reduced lower than the minimum value that the GUI allows.

Best Regards,

Diego Abad

0 Rama Balachandran 3 months ago in reply to Diego Abad Sajamin

Prodigy 10 points

Thanks, Diego, much appreciated. I presume this is a GUI limitation, not a hardware limitation of this EVM kit. Am I right in thinking that? If so, with changes to the configuration file, I should be able to achieve the objective, correct?

0 Diego Abad Sajamin 3 months ago in reply to Rama Balachandran

TI__Genius 10462 points

Hi Rama,
You can change it so it allows it, but you can expect errors to happen if so since the GUI is meant to be used with the specified range for it. For more information, please look at this guide:software-dl.ti.com/.../ch_config.html
Best Regards,
Diego Abad

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

EVM430-FR6043: Reducing F1 value in FR6043