Connecting multiple MSP-GANG

Prad1

Other Parts Discussed in Thread: MSP-GANG, MSP430F5341

Hi,

We are using MSP-GANG to program MSP430F5341 devices,
We would like to know if it is possible to connect multiple MSP-GANG to a single PC.

Currently we have 3 MSP-GANGs and would like to know if there is any option
to use these 3 programmers(on a single PC) to program 24 MSPs at a time.
I have heard about Multi-FPA API-DLL in case of GangPro430(Elprotronics)
will it be supported for MSP-GANG also?

Regards
Prad.

over 10 years ago

0 Ryan Brown1 over 10 years ago

TI__Guru**** 202106 points

Hi Prad,

The MSP-GANG was created in cooperation with Elprotronics and it should be possible to connect several to a single computer. Just have multiple MSP-GANG Programmer GUIs open and ensure that each is connected to a different MSP-GANG (via com ports). But to make absolutely sure about this, contact Elprotronics.

Thanks,

Ryan M. Brown

0 Prad1 over 10 years ago in reply to Ryan Brown1

Genius 3825 points

Hi Ryan

Thank you,

I contacted Elpro and got the answer that we need to modify MSP-GANG.dll file to support
mutiple programmers on a single PC.
But currently they seems to be busy to prepare such DLL files.
Can I assume that TI is not involed in building MSP-GANG GUI software?
Is it possible to release such software(Multi programmer) in future?

Regards
Prad.

0 Ryan Brown1 over 10 years ago in reply to Prad1

TI__Guru**** 202106 points

Prad,

There are no future plans to release multi programmer software in the future that I know of. The DLL files will have to be modified as suggested by Elprotronics.

Thanks,

Ryan M. Brown

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

Connecting multiple MSP-GANG