MSP430FR59471: Hardware tools for MSP430FR59471IRHAR

Lavi Weinstein

Prodigy 170 points

Part Number: MSP430FR59471
Other Parts Discussed in Thread: MSP430FR5947, MSP-FET, MSP-TS430RHA40A,

I'm going to use MSP430FR59471IRHAR in my design.

What evaluation board and programming/debugging tools will I need for working with this device?

Thanks.

over 7 years ago

0 Ryan Brown1 over 7 years ago

TI__Guru**** 202106 points

You can use the MSP-TS430RHA40A EVM, the only difference is that pin 30 does not require the 470 nF pulldown capacitor connected to it (C9) as the MSP430FR5947(1) devices do not have a VCORE. All other pins line up correctly. You can use a MSP-FET or eZ-FET to program/debug this device.

Regards,
Ryan

0 Lavi Weinstein over 7 years ago in reply to Ryan Brown1

Prodigy 170 points

Thank you Ryan.
1) Does your answer mean that I have to remove pulldown capacitor (C9) from the evaluation board in order to work with MSP430FR59471?
2) Just to be shure - does MSP-FET430UIF apropriate for programming of above MC?

0 Ryan Brown1 over 7 years ago in reply to Lavi Weinstein

TI__Guru**** 202106 points

You do not have to remove C9 for the EVM to work with the MSP430FR59471 but should be removed if you plan on using P4.4, and the MSP-FET430UIF is included with supported devices (Table 1 of SLAU647): www.ti.com/.../slau647f.pdf

Regards,
Ryan

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430FR59471: Hardware tools for MSP430FR59471IRHAR