Linux/MSP430-FLASHER: I want to use Mspfet on the Raspberry 2.

suchang lee

Prodigy 10 points

Part Number: MSP430-FLASHER
Other Parts Discussed in Thread: MSP-FET430UIF, MSP-FET

Tool/software: Linux

hi~
I want to use Mspfet on the Raspberry 2.

I installed mspdebug and etc libs. but it's not working

so I have two questions.

1. Is it possible to run on the raspberry2 ?
2. if it's possible, what is a driver name on the list?
manpages.ubuntu.com/.../mspdebug.1.html

please help me
thanks.

over 6 years ago

0 Christoph Schweers over 6 years ago

Intellectual 475 points

suchang lee said:

1. Is it possible to run on the raspberry2 ?

No, Raspberry Pi uses a CPU based on ARM architecture while MSP-FLASHER-LINUX is compiled for a x86 architecture CPU.

Regards

0 Clemens Ladisch over 6 years ago

Guru 186000 points

Please note that "MSP430-FLASHER" is a different software that you are not actually using.

On my desktop, I'm using tilib, but I'm note sure if it is possible to compile libmsp430.so on ARM.

As far as I can see, the built-in drivers of MSPDebug support only the older MSP-FET430UIF but not the MSP-FET.

0 zrno soli over 6 years ago

Guru 33093 points

I guess that you already know for this...

http://etchingpathways.blogspot.hr/2012/12/raspberry-pi-meets-ti-launchpad-msp430.html

This one is new, direct connection between Pi GPIO and JTAG target device...

http://forum.43oh.com/topic/10035-4-wire-jtag-with-mspdebug-and-raspberry-pi-gpio

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

Linux/MSP430-FLASHER: I want to use Mspfet on the Raspberry 2.