• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 79 subscribers
  • Views 1042 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

MSP430F5509: the change about the ZHCS897G UART BSL

Xiao Zhu2
Expert 3215 points

Part Number: MSP430F5509

Hello Team

Could you help explain why have this change？ Detail please see following informationt.  Why apply a 1M resistor to ground?

  • 0
    TI__Guru**** 221947 points
    Hello Xiao,

    I suspect ZHCS897G is not the correct name of the part you are referring to and that some additional information was not attached correctly. Please provide the correct part and resource you have a question about.

    Regards,
    Ryan
  • 0 in reply to Ryan Brown1
    TI__Expert 3215 points

    msp430f5509.pdfHello Ryan

    Thank you for your replay. Attached is the datasheet. In page 21,  The note describe that Applying a 1-MΩ resistor to ground is recommended. the question is that if  not apply this resistor, what will happen?

  • 0 in reply to Xiao Zhu2
    TI__Guru**** 221947 points
    Hi Xiao,

    Thank you for clearing up this confusion. As stated in the datasheet, the PUR pin is used to invoke the default USB BSL on a logic high. Therefore a weak pull-down resistor should be applied to this pin to make sure that a floating condition does not falsely trigger the USB BSL. This information has nothing to do with the UART BSL mentioned in the post title and the PUR pin should be grounded if USB is not being used.

    Regards,
    Ryan

**Attention** This is a public forum