EVM430-FR6989: need EVM430-FR6989 eZ-FET firmware

Kissn Liu

Expert 1245 points

Part Number: EVM430-FR6989

I have a EVM430-FR6989 board in hand, but when debug using IAR,it says "could not set device voltage"

so i want to get the eZ-FET firmware from TI to update the eZ-FET firmware in board.

please let me know, is it OK to give me the eZ-FET firmware?

over 6 years ago

0 Ryan Brown1 over 6 years ago

TI__Guru**** 202106 points

Only the eZ-FET lite firmware is provided, but this does not include the DC-DC converter for current measurement or variable voltage settings: processors.wiki.ti.com/.../EZ-FET_lite

Has this board been used before or is it brand new? Did anything occur before this error appeared?

Regards,
Ryan

0 Kissn Liu over 6 years ago in reply to Ryan Brown1

Expert 1245 points

hi Rayn

the firmware you give me can not use too.

can you give me the firmware that match the board from the board designer?

0 Ryan Brown1 over 6 years ago in reply to Kissn Liu

TI__Guru**** 202106 points

Hi Kissn,

You misunderstood my original reply, the eZ-FET lite code cannot be used on eZ-FET hardware but is the only version currently available for customers. I am currently contacting the firmware owner to see if it can be provided, in the meantime can you try updating the firmware through a different IDE like CCS or FET-Pro430 or see if this software is able to correctly communicate with the target device?

Thanks,
Ryan

0 Kissn Liu over 6 years ago in reply to Ryan Brown1

Expert 1245 points

i tried all method you said,but it does not make sense.
i look forward to the EVM ez-FET firmware so much
thanks a lot.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

EVM430-FR6989: need EVM430-FR6989 eZ-FET firmware