Hi, i am trying to interface 2 potentiometer in channel 0 and channel 2 of MSP430F249-ep ADC. Here i attached the initialization steps for ADC, by this way only i initialized my channel. I checked my results in proteus, Channel0 of ADC works fine but channel 2 doesn't get initialized. Please point out my mistake.
if switch1 pressed channel 0 should be active
ADC12CTL0 = SHT0_2 + ADC12ON; // Set sampling time, turn on ADC12
ADC12CTL1 |= CSTARTADD_0 + SHP; // Use sampling timer
ADC12MCTL0 |= INCH_0; /* channel 0*/
ADC12CTL0 |= ENC + ADC12SC; // Conversion enabled
value = ADC12MEM0;
if switch 2 is pressed channel 2 should be active
ADC12CTL0 = SHT0_2 + ADC12ON; // Set sampling time, turn on ADC12
ADC12CTL1 |= CSTARTADD_2 + SHP; // Use sampling timer
ADC12MCTL2 |= INCH_2; /* channel 0*/
ADC12CTL0 |= ENC + ADC12SC; // Conversion enabled
value = ADC12MEM2;
