CCS/CC2650: Using MSP430 Blood pressure library (http://www.ti.com/tool/TIDM-BPM) for CC2650

nilesh passi

Part Number: CC2650

Tool/software: Code Composer Studio

I am using CC2650 ble to measure Blood pressure and was following the reference design for MSP430 (http://www.ti.com/tool/TIDM-BPM ) but not able to utilize blood pressure library as there is not provision to pass the raw value

over 4 years ago

0 James Evans over 4 years ago

TI__Mastermind 49692 points

Hi Nilesh,

Unfortunately, this library may not support the CC2650 since it has a different architecture than the MSP430. You'll probably need to acquire the raw ADC values manually from MSP430 and send them to the CC2650 over UART. Otherwise, you'd need to implement the same functionality on CC2650 without using MSP430 which could be challenging.

Regards,

James

0 nilesh passi over 4 years ago in reply to James Evans

Prodigy 40 points

thank you for your response , i can not use MSP430 and CC2650 both as this product is size constraint and cost will also increase,can any one help me with algorithm as i have implemented the hardware as per reference design and I am getting a graph as shown below

0 J Lindh over 4 years ago in reply to nilesh passi

TI__Guru 57865 points

Hi Nilesh,

That is application level dependent and something you would have to develop yourself.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

CCS/CC2650: Using MSP430 Blood pressure library (http://www.ti.com/tool/TIDM-BPM) for CC2650