Tool/software: Code Composer Studio
Good evening. Brand new to the TI MSP platform (and embedded software for that matter) and I'm trying to get started. I recently purchased the above mentioned developer board and installed CCS 10. I connect the board to my computer via the USB cable but I get the following error when clicking Detect Board: {"msg":"COM4: Could not power up the device.","name":"COM4","type":"require-update"}. I read the user guide but unless I'm missing something (which is totally possible) I don't see anything regarding troubleshooting connecting to a PC. I have the MSP Debug Interface attached to COM4 (COM3 is the Application UART1). Do I have the incorrect baud rate perhaps? I didn't see anything about what baud settings should be configured for proper connection. Any assistance would be helpful to get me going. And apologies if this has been addressed before. Please point me to the correct thread if so; my searches weren't turning up anything relevant. Thank you!