Other Parts Discussed in Thread: MSP430F5529
Tool/software: Code Composer Studio
Hi E2E,
I have ordered a PCB with MSP430FR5728_RGE on it.
I am trying to burn it with MSP430F5529 Lanuch pad.
I followed the instructions and managed to burn a simple code for blinking my leds.
After the initial burn, i either get this error:
MSP430: Trouble Writing Memory Block at 0xc200 on Page 0 of Length 0x56: Could not erase device memory
MSP430: File Loader: Verification failed: Target failed to write 0x0C200
MSP430: GEL: File: C:\Users\xalon\workspace_v10\Jig_Case_Testing\Debug\Jig_Case_Testing.out: Load failed.
After a while of trying to check connection issues and restarting CCS and the PC, now all i get it:
MSP430: Error connecting to the target: Unknown device
A friend suggested i might've written over the boot-loader at the target MCU, so now it's not able to burn again.
I tried searching through the forum and haven't found an answer to solve my issue.
Thanks,
Alon