Part Number: MSP-CAPT-FR2633
I have an older eval kit of the MSP-CAPT-FR2633 that came with the CAPTIVATE-PROMITY Rev B board. I could not find any example files for it, and upon further research I found it was discontinued.
If possible I would still like to use it for some basic functions for testing: Left zone enables a GPIO. Right zone enables a different GPIO. Center zone disabled. The hand motions across the left or right zone will alternate enabling/disabling their respective GPIOs, so that I can power cycle external circuits.
I tried setting up in the Captivate Design Center the Proximity sensor, but the element count only allows for 1, I cannot select 2 (for the left/right zones). Am I doing this right?