MSP430F67791A: Own GUI Read data from MSP430f6779 with MSP430F5529lp

EST

Part Number: MSP430F67791A

I have tested MSP430F67791A+ISO+HID BRIDGE with the EMDC GUI and am getting the desired results. But i want to read data using my own GUI or Serial Port Utility.

How to read data from MSP430F67791A+ISO+HID BRIDGE with the own GUI or Serial Port Utility?

over 3 years ago

0 Leonardo Estevez over 3 years ago

TI__Genius 12615 points

Hi,

There is a relevant thread on this topic which I believe will answer your questions:

https://e2e.ti.com/support/microcontrollers/msp430/f/166/t/725083

BR,

Leo

0 EST over 3 years ago in reply to Leonardo Estevez

Intellectual 280 points

Hi Leonardo Estevez,

Thanks for your re[ply.

I have tested MSP430F67791A with UART Communication directly without using HID bridge in commands are 0X55,0XAA,0X06,0X04,0X01,0X01,0X01,0X07,0X00. It's work well.

But I will try to connect MSP430F67791A + ISO + HID BRIDGE and send commands are 0X55,0XAA,0X0A,0X04,0X02,0X01,0X01,0X07,0X00. It's doesn't work.

Please send me a correct commands.

Thank You!

0 James Evans over 3 years ago in reply to EST

TI__Mastermind 49692 points

Hello,

Please refer to the Protocol section in the latest version of the EMDC Technology Guide (v1.40 currently). The command tables will help you figure out the structure of the UART commands and how to send them.

You don't need the HID bridge when using a serial terminal. The USB HID bridge is required for converting UART packets to USB packets for the EMDC GUI and vice versa when sending commands from the GUI to the target.

Regards,

James

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430F67791A: Own GUI Read data from MSP430f6779 with MSP430F5529lp