MSP430F6733: How to use BSL-SCRIPTER to read back the flash content and store as a txt file? how to use the "TX_DATA_BLOCK" command?

Yue TANG

Part Number: MSP430F6733

Team,

I can't find an example to show the usage of the TX_DATA_BLOCK command in BSL-SCRIPTER. I called this function as below and the BSL-SCRIPTER crashed. please kindly suggest how to use this command.

LOG
MODE 6xx COM98
VERBOSE
MASS_ERASE
TX_DATA_BLOCK

TX_DATA_BLOCK .\my.txt

over 6 years ago

0 Britta Ruelander over 6 years ago

TI__Genius 10860 points

Hi,

please take a look at the Bootloader (BSL) Scripter User's Guide section 2.4.19 which describes how to use the TX_DATA_Block command.

The command has three mandatory parameters and the User's Guide gives some examples on how those could look like.

Please let me know if you need further assistance.

Best regards,

Britta

0 Britta Ruelander over 6 years ago

TI__Genius 10860 points

Hi,

were you able to get the TX_DATA_BlOCK command running?
Please let me know if you need further assistance or verify the given answer. In that case I'll go ahead and close the thread.

Best regards,
Britta

0 Britta Ruelander over 6 years ago

TI__Genius 10860 points

Please note that I closed this thread.
In case you need further assistance go ahead and re-open it by replying to this thread.

Best regards,
Britta

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430F6733: How to use BSL-SCRIPTER to read back the flash content and store as a txt file? how to use the "TX_DATA_BLOCK" command?