MSP-EXP430FR2355: GUI composer can't read 0x200C

David Wood

Whenever I start a GUI with my MSP-EXP430FR2355, the window always says that it can't read 0x200C. I have looked everywhere to figure out what that number is but to no avail. Does anybody know what number the composer is talking about?

over 4 years ago

0 Matt Calvo over 4 years ago

TI__Genius 13650 points

David,

Are you using a custom GUI designed in GUI Composer or is it a TI provided GUI such as the Out-of-box demo for the MSP-EXP430FR2355?

Best regards,

Matt

0 David Wood over 4 years ago in reply to Matt Calvo

Intellectual 360 points

It is a custom GUI. I have tried to base my GUI off of the OOB example, but as soon as I change any binding I get this error.

0 Matt Calvo over 4 years ago in reply to David Wood

TI__Genius 13650 points

David,

Are you able to use the OOB GUI with no problems? If so, what changes have you made which resulted in that specific error? Are you able to backtrack your steps to pinpoint when a specific change breaks the functionality of the GUI?

Best regards,

Matt

0 Matt Calvo over 4 years ago in reply to Matt Calvo

TI__Genius 13650 points

David,

It has been about a week since I've heard from you so I am going to assume that you resolved your issue. If that is not the case feel free to provide further detail or if this thread locks you can post a new E2E thread.

Best regards,

Matt

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP-EXP430FR2355: GUI composer can't read 0x200C