Flashing LM4F232H5QD of ek-LM4F232 board using xds-510

sayed tausif

Intellectual 380 points

Hi,

I want to flash EK-LM4F232 USB+CAN evaluation board using XDS-510 (Digital Spectrum).

Whether XDS-510 support EK-LM4F232 flashing, or I need to purchase XDS-560 for this purpose.

kindly advice!!

over 9 years ago

0 Amit Ashara over 9 years ago

TI__Guru**** 244380 points

Hello Sayed,

Why do you need to have XDS510, when a XDS100 (lower cost) can do the same job. What is important is to study the header of the XDS510 w.r.t the JTAG connector on the eval board. This wiki will help you with the pin out

processors.wiki.ti.com/.../JTAG_Connectors

Regards
Amit

0 sayed tausif over 9 years ago in reply to Amit Ashara

Intellectual 380 points

Hi,

I only have XDS510, I already tried the pin-out as provided at wiki site.
But I didn't succeed!
Is there any adaptor available for XDS510 that will connect it to eval kits 10 pin JTAG port?
provide me the part number!!

0 Amit Ashara over 9 years ago in reply to sayed tausif

TI__Guru**** 244380 points

Hello Sayed,

I have not seen a 14 pin to 10 pin adapter. You would have to make one with a 2 layer PCB.

Regards
Amit

Arm-based microcontrollers

Arm-based microcontrollers forum

Flashing LM4F232H5QD of ek-LM4F232 board using xds-510