the pic show, when motor run in low speed, the current waveform is abnormal.
As shown by the red mark ,during the test, the current was cut off.
Is this because of abnormal commutation? Or is it because the current is too small? Do you have any comment on this?
(yellow one is U voltage, Green one is Iout. Blue one is FG signal)
(Motor parameters :15 pole pairs, kV=16rpm/V, phase resistance=0,17Ohm, Phase inductance=0,33mH)
o PWM frequency : The frequency sent by MSP430, 20kHZ
o ADVANCE: 0°(R27 = 0 Ω)
o MODE: Digital Hall Input, Synchronous modulation, ASR and AAR Disabled(R22 = R29 = DNP)
o SLEW : 25 V/μs (R26 = 0 Ω)
o ILIM: MCT8316 current limit has not been changed (8A)
