DRV10987EVM: GUI issue with USB2ANY

Sayali Shinde

Part Number: DRV10987EVM
Other Parts Discussed in Thread: DRV10987, USB2ANY, DRV10983

Hi Team,

we are testing evaluation board of DRV10987 . as per guide I have install GUI but it is showing below error. when I click ok it pop up another window.

as per above ss after pressing S1 it doesn't go ahead . is there any other way to solve these issue.

Regards,

Sayali

over 2 years ago

0 Michael Arrant over 2 years ago

TI__Expert 3535 points

Hi Sayali,

I've seen this before, it usually happens when a new USB2ANY is being used.

What you'll need to do is completely unplug the USB2ANY from your computer. After that, use a small object to press the S1 button of the side of the USB2ANY and hold it down. While holding it down, plug the USB2ANY into your computer. Keep holding the S1 button down for a few more seconds then release. The USB2ANY should update the firmware after that and you'll be good to go.

I've noticed when doing this I thought I was pressing down the S1 button but I was pressing it down at an angle and it didn't actuate the button. So that could be the issue you're running into as well.

Regards,

Michael

0 Sayali Shinde over 2 years ago in reply to Michael Arrant

Intellectual 705 points

Thanks Michael,

Its working , firmware got updated but after that I got another error.

I tried to many time to restart GUI but it show same error.

Regards,

Sayali Shinde

0 Michael Arrant over 2 years ago in reply to Sayali Shinde

TI__Expert 3535 points

Hi Sayali,

Ok good you were able to update the firmware. Please make sure the EVM is properly powered up according to the datasheets spec. After that, check to see if the device is in sleep/standby mode. This can be done by setting the voltage on the SPEED pin accordingly.

I found another E2E thread and they were having a similar problem. If the suggestions I made above don't work you may want to take a look at this thread. Here is the LINK.

Please let me know if you resolve your issue.

Regards,

Michael

0 Sayali Shinde over 2 years ago in reply to Michael Arrant

Intellectual 705 points

Hi Michael,

I tried above option also by installing software in other location but it didn't work. One more thing when I open GUI it asked to select IC number , after selecting DRV10987 it shows error for DRV10983. is there any other way to solve this error.

Regards,

Sayali

0 Michael Arrant over 2 years ago in reply to Sayali Shinde

TI__Expert 3535 points

Hi Sayali,

Try checking the USB connection from the DRV10987 EVM. It could be that this jumper is not properly plugged in.

Next, let's check that the DRV10987 is not damaged by seeing the voltages on Vreg, V3P3, V1P8, and VCP. What voltage are you using on VCC?

Thanks,

Michael

0 Sayali Shinde over 2 years ago in reply to Michael Arrant

Intellectual 705 points

HI Michael,

Thank you for your support ,the problem got solved.

Regards,

Sayali.

+1 Michael Arrant over 2 years ago in reply to Sayali Shinde

TI__Expert 3535 points

Hi Sayali,

Great, I'm glad you were able to resolve this. I'll close this thread.

Regards,

Michael

Motor drivers

Motor drivers forum

DRV10987EVM: GUI issue with USB2ANY