I am using the MSP-EXP430FR5739 to flash firmware to the DRV8343H-Q1EVM and the files are set up for a different MSP board. In the forum pages I have read, it says that the board I have will work but I keep getting an error about the memory map not matching. Are there separate files that I need or is there an easier way to alter the files?
Hi Salvatore,
Linking the forum page here: https://e2e.ti.com/support/motor-drivers-group/motor-drivers/f/motor-drivers-forum/1045673/faq-drv8343s-q1evm-how-to-flash-firmware-onto-the-drv8343x-q1evm
To get the MSP-EXP430FR5739 to connect, make sure you remove the 3V3, GND, SBWTDIO, and SBWTCK jumpers on the jumper bridge to disconnect power and the eZ-FET debug signals from the MSP430FR5739. This will force the power and SPI-by-wire pins to connect the 50-mil header instead.
It will look like this:
The blue circle are the jumpers removed, and the red circle is the 50 mil header that connects to the MSP430F5529 on the DRV8343x-Q1EVM. Also ensure in CCS you go to the Project Properties and set up the target as MSP430F5529, not the MSP430FR5739.
Thanks,
Aaron
